Welcome to the ACE Index, the
definitive web directory for locating
camera equipment, used cameras, photo labs, camera repair
and photo equipment manufacturers in 34 countries.
This is an archived message in our
forum
Posted by J. Ramón Palacios on October 05, 1999 at 12:20:41:
In Reply to: Re: Very dark slides : somehow I'm confused posted by eric jorgensen on September 28, 1999 at 10:24:36:
:
: : : : I shot a load of 1600 ASA film on 400 ASA, they have come
back real dark after processing, Is there any way they can be
printed more clearly?
: : : Response:
: : : You have used two full f/stops more, I would imagine it
would be very difficult. Although highly dependant on film
latitude, one f/stop is manageable, two may be too much.
: : : Sorry. Shoot again.
: : (Sorry, same response, but in the previous one the link was
misspelled).
: If you shot 1600 ASA film at 400 ASA settings, the slides would tend to be be overexposed and not too dark, but too light. If you shoot 400 ASA film at 1600 ASA settings the slides would be underexposed (dark) and would benefit by push processing. In the original case I guess pull processing would be the procedure to follow but once the film is developed - not much can be done, I think.
: Someone needs to straighten me out if I have this backwards.
thanks - Eric Jorgensen (pretty much a beginner)
Response:
Maybe the source of confusion is between negatives and slides.
1600 ASA is a very fast film. If your camera settings were at
400ASA, a slower film in comparison,
the shutter will give the film an overexposure.
Negatives will be very dark from too much light, positives will
be very light as a consequence.
end of archived message
[ Post New Message ] [ View Current Messages ] [ FAQ ]